Team Nisca Nisca PR5350, Operation Manual

Page: 23 / 64

20
3
- d-1) For SCSI type interface
When constructing a system with the plural number of devices, connect the SCSI
compatible terminal devi ces ( SCSI devices) i ncl udi ng t his printer i n the chai n
connection as shown in the following fi g .
Those SCSI devices designed to suit for such connection has two SCSI connectors.
For exa mpl e, one i s
used for interface
cable for computer
and
the other for
connecting the other
SCSI device.
Setting SCSI ID
Each SCSI devices to be connected in the SCSI chain must be identified with
individual ID numbers, which are called as "SCSI ID No.". There are 7 SCSI #s.
as a specification and each dev ices must be assigned with different ID numbers.
To set the ID numbers for this printer system, follow the instruction of the
system. The default of this printer is "4".
◆
Set the ID No. with the user menu from the operation panel
1. Entering into the User Menu
Press and hold the Menu key as
shown in
the fig. till the
displayed letters change from
"Input Command" to "User Mode".
When
the key is released, the
following selection is shown under
the "User Mode", "CLR:BACK EXE:GO".
By pressing EXE key here, you can enter
the User Menu.
2.
Selecting the SCSI ID setting Menu
The initial display at the User
Menu is "User Mode/Push MENU key".
Following this display, select
"SCSI ID Select" with the MENU key.
3. Setting the SCSI ID
"ID:_" is displayed under the "SCSI ID Select" and the numerals of 0 - 7 is
shown on the part of _. Enter appropriate number on this part using EXE key.
4. Confirming the SCSI ID
After checking the number, select "Return to Normal Mode" with MENU key and
press EXE key to return to "Ready to Print" . The setting is now confirmed .
□
The SCSI ID No. shall not be the same as that for the other device.
→
The system will not operate normally.