Team Nisca Nisca PR5300, Operation Manual

Page: 22 / 57

- 20 -
Setting the Terminating Switch
Depending on the system structure, this printer may be
connected at the end or middle of the SCSI chain
(daisy chain) . Turn ON or OFF the terminating switch
accordingly as shown in the following figs.
In case of the printer is in the middle:
Terminating Switch should be" OFF"
Default is"OFF".
If the printer is at the end of the line,
Terminating Switch should be "ON"
Do not connect any device other than the specially designated device which
are presented by Nisca, to the connector for the options. ( Refer to the printe
back view in the Section 2, Name of each parts )
¤Connected device may be damaged.
¤Circuit voltage rating: 24 Vdc, 5 Vdc
When connecting the cable, do not forget to turn OFF the power switch of the
printer and all other devices to be connected.
¤It may cause a trouble to entire system and there is a possibility of big
damage such as losing the stored data.
Regarding the order of turning ON or OFF of the power of each devices at the
time of starting or finishing the system, the instruction of the system must
be observed.
Generally, when starting, the peripheral devices shall be started first and the
host computer at the last. When finishing, in opposite order.
¤It may cause a trouble to entire system and there is a possibility of big
damage such as losing the stored data.
Starting
Ending
TERMINATOR
ON
OFF
ON
OFF
T ERMINATOR
ON
OF F
ON
OFF