Teagle Tomahawk 1010, Instruction Manual

Page: 10 / 44

Bales can be loaded into the machine in two ways, using
a loader or by self-loading using the machine tailgate. If
a loader is used, simply load the bale into the bale
chamber such that it is fully inserted, but do not ram it
against the crossbeaters.
When loading the machine, it will be necessary to
run the bed chain to help self load the bale into the
chamber. However, excessive use of the bed chain for
this purpose may cause material to enter the rotor
housing resulting in a blockage during machine start up.
The tailgate is designed to load bales into the chamber
of the machine. Where a telescopic tailgate is fitted, it is
important to only self load with it in the retracted
position.
To retract the tailgate:
1.) Lower the tailgate.
2.) Switch off the tractor and remove the key.
3.) Remove the extension retaining bolts.
4.) Slide the rear tailgate section towards the machine,
replace the retaining bolts in the retracted position.
Figure 1. Telescopic Tailgate Setting
10.2 Self Loading
Make sure the drawbar is securely attached to the
tractor as self loading may cause it to lift.
For large rectangular bales, place the bale on the
ground with one end against a solid object. For easy
removal of the strings place the bale on its side so that
the strings are not in contact with the ground. In the
case of quadrant bales, place the bale with the knots on
the top. Reverse the machine with the tailgate lowered
until the bale slides up the tailgate into the bale
chamber. Raise the tailgate until it is horizontal and
engage the bed chain to move the bale fully onto the
tailgate.
Make sure that the bale is not forced against the
crossbeaters as this may cause problems when
starting the machine.
Before removing the strings, place the posts in the
sockets on the tailgate and put the chain around the rear
of the bale to avoid the risk of crushing from unsecured
material.
To load round bales, reverse the machine under the
bale so that the bale rests against the tailgate. Lift the
tailgate slightly and drive forward a short distance before
raising the tailgate further. With the bale on the tailgate
cut the strings or netwrap on the machine side of the
bale as low as possible and remove around the top of
the bale. Rope hooks are positioned on the underside of
the tailgate to tie partially removed twine and netwrap to.
Raise the tailgate, the bale will roll into the machine
leaving the twine or netwrap tied to the tailgate allowing
easy removal.
10.3 Multiple Bale Loads
The Tomahawk 1005/1010 are large machines designed
to carry several bales in a load. To maximise the
carrying capacity of the machine it is recommended that
the telescopic tailgate be extended as per Figure 1. A
suitable mechanical loader should now be used for
loading. The machine is now capable of handling two
large rectangular bales 1.2x1.3x2.7m or three 2m round
bales as shown in figure 2 below.
Figure 2. Tomahawk T1005/T1010 Loaded
10.4 Bale Lift
In certain territories (not UK) the machines are available
with a bale lift in the body of the machine to permit a
portion of the load to be lifted from the bed chain. This
can be advantageous in reducing the amount of
material presented to the crossbeaters ensuring smooth
discharge. Operation of the bale lift is by means of the
chute selection buttons on the bottom left of the control
box. When fitted, the feature should be used as shown
in figure 3 below.
Figure 3. Bale Lift Use
6