408-35042
Rev C
7
of 26
3.
APPLICATOR INSTALLATION AND REMOVAL
DANGER
To avoid personal injury, make sure the power and air source to the machine is turned OFF and power cord/air supply are
disconnected before installing or removing the applicator.
NOTE
Always remove the Ram Transportation Collar after installing the applicator on a machine and be sure to install the Ram
Transportation Collar back onto the applicator ram just prior to removing the applicator from the machine.
NOTE
With the applicator in the machine, never attempt to cycle machine under power without terminals properly loaded, as
described in Section 4; otherwise, the tooling may be damaged.
DANGER
To avoid personal injury, the applicator should be used only in an appropriate terminating machine. The pressurized air supply
should only be connected after the applicator is properly installed in the terminating machine.
AMP-O-LECTRIC Machine and Mo
del “K” Machine (with Mini
-Applicator Conversion)
A.
Installation
This machine must be equipped with Machine Conversion Kit PN 690675-2 to adapt it for use with the
OCEAN 2.0 applicators. The kit includes applicator Instruction Sheet
, which explains how an
applicator with mechanical feed is installed and removed from the machine.
B.
Removal
1. Turn off, and disconnect, the power to the machine.
2. Unload the applicator as described in Section 4.
3. Remove the Hold-Down Bracket and Movable Stop, then slide the applicator away from the stop on
the base mount until the Ram Post is clear of the machine ram.
Model “T” Terminating Unit
NOTE
For the Atlantic Applicator only.
A.
Installation
1. Turn off and disconnect the power to the machine.
2. Push in the Release Bar on the quick-change base plate. The Locking Latch will pivot
downward
.
3. Place the applicator on the quick-change base plate, then slide it back until two notches engage the
stops at the back of the plate. At the same time, guide the Ram Post into the Ram Post Adapter.
4. Flip the Locking Latch up to secure the applicator in place.
B.
Removal
1. Disconnect the power cord.
2. Cut the terminal strip one or two terminals from the end of the applicator.
3. Push in the release bar on the quick-change base plate. The Locking Latch will pivot
downward
.
4. Slide the applicator forward until it is clear of the Ram Post Adapter.
