408-35042
Rev C
13
of 26
Figure 14
5. Turn the Stroke Length Adjustment Screw
counterclockwise
to reduce the stroke length or
clockwise
to increase the stroke length.
6. Tighten the Stroke Length Adjustment Lock Screw.
7. Repeat steps 1 through 6 as required until the proper stroke length is achieved.
Note
: The terminal
might not be centered over the Anvil; this will be adjusted at a later step.
If the feed pawl stroke length is satisfactory, and the backstroke position is correct, but the lead terminal is
not centered over the Anvil, the stroke is correct; however, the Feed Pawl position is incorrect. In this
case, an adjustment to the fine feed screw is required.
8. Adjust the Feed Pawl position as follows:
Loosen the Fine Feed Adjust Lock Screw on the side of the Feed Finger Holder to allow the Fine
Feed Adjustment Screw to turn (see Figure 14).
NOTE
Do not remove the Fine Feed Adjust Lock Screw. A nylon plug is captured behind the lock screw. Loss of this plug will cause
damage to the fine feed adjustment screw threads when the lock screw is tightened.
9. Adjust the Feed Pawl position by turning the adjustment screw
counterclockwise
to move the Feed
Pawl away from the Anvil and
clockwise
to move the Feed Pawl toward the Anvil. Center the terminal
over the Anvil.
10. Re-check the adjustment for the proper position and stroke as described in Step 1. Repeat the
adjustment procedure as necessary and tighten the Fine feed Adjust Lock Screw.
Stroke Length Adjustment Screw
Stroke Pivot
Stroke Length Adjustment Lock Screw
Fine Feed Adjustment Screw
Fine Feed Adjust Lock Screw
Feed Pawl
Feed Pawl Holder
Strip Guide Locking Screw
Strip Guide Adjusting Screw
