409-5861
10 of 26
Rev B
3.4. Installing Terminating Machines 122754-3 and -4 into Komax Model 43 Machine
1. Install the interface cable (part number 189070-1) and power cable (part number 189276-1).
2. Attach the remote display unit to the reel support post. Slide the display assembly over the post and
position as desired. Tighten the clamp lever to secure the display assembly to the post.
3. Connect the ribbon cable (part number 189425-1) located on the top of the controller to the
9 -pin D connector located on the side of the remote display.
4. Install the tonk assembly (supplied with the installation kit) onto the ram post adaptor of the Model “G"
terminating machine. Refer to Figure 8 for proper installation of the tonk assembly.
Figure 8
Station 1
Station 2
Station 3
Tonk Assembly Setup for Komax Model 43 Machine
Position A (Ref)
Ram Post
Adapter
Use Position B
Tonk Assembly
122725-1
Position B (Ref)
Ram Post
Adapter
Tonk Assembly
122725-2
Use Position A
Tonk Assembly
122725-1
Use Position B
Position A (Ref)
Ram Post
Adapter
