!
CAUTION
409-5861
13 of 26
Rev B
5. OPERATION
5.1. Applicator Installation
Make sure that the manual precision adjustment lever has been returned to the 0.00-mm [.000-in.] position before
installing the applicator. Refer to Paragraph 7.3.
1. Loosen the thumbscrew on the applicator base clamp and slide the clamp down. See Figure 9.
2. Lower the ram lock mechanism by loosening the thumbscrew at the front of the ram post adaptor.
3. Place the applicator onto the base plate of the terminating machine. Slide the applicator back until the
two notches in the applicator base plate engage the rear stops. At the same time, guide the applicator ram
into the ram post adaptor, making sure the applicator ram engages the ram lock mechanism. See
Figure 9
Ram Post Adapter
Removable Rear
Stop (Ref)
Alternate Mounting Position
for Removable Stop (Ref)
Thumbscrew for
Applicator Base
Clamp
Base Plate of Model “G”
Terminating Machine
Thumbscrew for Ram
Lock Mechanism
