409-5861
14 of 26
Rev B
.
Base Plate of Model “G”
Terminating Machine
Rear Stop(s)
Thumbscrew for Ram
Lock Mechanism
Ram Post Adaptor
Applicator Pad
Applicator Ram
Front Pad of Ram
Post Adaptor
Thumbscrew
Applicator Base Clamp
Typical Applicato
NOTE
i
Figure 10
4. Slide the applicator base clamp UP and re-tighten the thumbscrew to secure the applicator in place.
When using Applicator 567200-1 (originally intended for the AMP-O-LECTRIC Model "K" terminating machine), remove
the thumbscrew for the applicator base clamp and the removable rear stop located on the right side of the base plate.
Re-install the rear stop at the alternate mounting position on the base plate. Refer to Figure 9.
5. Set the crimp height and insulation crimp discs so that the letters and numbers on the applicator pad
align with the front pad on the ram post adaptor. See Figure 10.
6. Secure the applicator ram to the ram post adaptor by turning the thumbscrew for the ram lock
mechanism
clockwise
until tight. See Figure 10. If the applicator is an air-feed type, connect the air lines to
the valve located on the right side of the terminating machine.
7. Adjust the reel support for side-feed or end-feed product, depending on the applicator being used.
