4
BA-PB3_IP_EN / F0354800
1
Safety
The machine was designed in accordance with the relevant international standards.
However, as with any technical product, hazards may arise if the system is not used
properly or is used for purposes other than its intended use.
Working with the machine can be dangerous and may result in serious or fatal injury. It is
therefore essential to protect yourself and others.
In addition to the safety instructions in this document, you must also comply with general
safety standards.
Caution
–
Danger!
When working with the machine, please note and observe the safety instructions and
requirements in these operating instructions because non-compliance may result in
serious or fatal injury.
1.1
Residual risks
This machine has been manufactured in accordance with the current state of the art.
However, it is impossible to eliminate residual risks.
Always adhere to the following safety instructions:
Caution
–
Electrical voltage!
•
Danger from high voltage
- Never direct the plasma beam at people or animals.
- Never touch the plasma nozzle or the plasma jet when the machine is in operation.
- Never touch the workpiece to be treated or its holder during plasma generation.
- Make sure that no third party comes into contact with the workpiece to be treated
or its holder.
- If electrically conductive materials touch the workpiece to be treated, these
materials must be earthed.
•
Danger from 230 V
- Do not start up the machine if damage is visible on the electrical connection, mains
cable or machine itself. Replace the damaged parts or have them repaired by a
qualified person.
-
The machine must be earthed.
-
Only connect the device to a power socket with earthing pins.
- Make sure that the electrical data on the rating plate corresponds to your electricity
supply.
