BA-PB3_IP_EN / F0354800
23
8
Taking out of service
To take the machine out of service, perform the following steps in the specified order:
1. Switch the machine off using the master switch (#1).
2. Disconnect the machine from the mains voltage supply: disconnect the power
connector.
3. Close the mains connection socket on the stand-alone unit with the cover cap.
4. Disconnect the compressed air supply hose from the maintenance unit for compressed
air supply (#5).
✓
The machine is out of service.
9
Cleaning and maintenance
Caution
–
High voltage! Danger of death!
High voltage is produced in the interior of the machine. This voltage is still present after
the machine is switched off.
- It is forbidden to open the machine.
- Before carrying out maintenance, servicing or repair work, always disconnect the
machine from the power supply.
Attention
–
Damage to machine!
Opening the machine may cause it to be damaged.
- It is forbidden to open the machine.
9.1
Cleaning
Only clean the outside of the machine.
- The machine must be cooled down, switched off and disconnected from the mains
voltage supply.
- Only clean the machine with a damp cloth.
9.2
Maintenance for the stand-alone unit
Replace the filter mats at least every 2000 operating hours. If working in environments with
high levels of dust, they may have to be replaced sooner. You can source the filter mats
needed as spare parts from
relyon plasma
GmbH.
To change the dust filters, proceed as follows:
