19
Settings on the device
Placing the video matching resistor
If the device is installed at the end of a TCS:BUS video
strand, the jumper for the video matching resistor must
be set.
Ex works the video matching resistor is placed in the
position
OFF
.
►
Pull off the jumper (video matching resistor) from the position
OFF
.
►
Place the jumper on the position
ON
(ill. 8).
Fig. 8: Placing the matching resistor
restart the device
►
Shortly press the
reset button
with a pointed object (ill. 9). The
device will restart.
The restart takes around 60 seconds. The LEDs remain off
during the boot procedure.
Fig. 9: device restart (reset button)
reset network settings and passwords
If the web interface is not available, you can reset the network set-
tings as well as the passwords to the factory setting.
The telephone book or project specific data are not delet-
ed.
Use the web interface for a complete upload of the facto-
ry settings.
►
Keep the WEL button pressed (8 s) by using a pointed object until
the green LED blinks slowly at first and then fast (ill. 10).
►
Release the WEL button . The network settings and password will
be reset.
The restart takes around 60 seconds. The LEDs remain off
during the boot procedure.
Fig. 10: reset network settings and passwords (WEL but-
ton)
Configuration
