8
01/2013
TCS TürControlSysteme AG, TCS Hotline Deutschland: [email protected]
Subject to technical changes.
www.tcsag.de
PI_AMI1090x-uk 1A
1
Initiate
Switch on the programming mode of the system
Power supply and control unit
Shortly press the
RUN/PROG push button LED blinks
Namenplate of the bell button module blinks.
Programming mode of the system is switched on
2a
Via voice connection
er
◄6s►
Establish voice connec-
tion to the front-door
station
Press button until the
negative acknowledgement
and positive acknowledgement
... and a ring tone at
the front-door and
indoor station sound
1)
Release
2b
alternatively
: Via floor push button
(indoor station is not available)
+
◄6s►
Press the floor push but-
ton two times, every time
a ring tone sounds
Press the button until a
negative acknowledgement
and positive acknowledgement
... and a ring tone at
the front-door and
indoor station sound
1)
Release
Repeat the steps until all bell buttons are programmed
3
End
Power supply and control unit
oder
Shortly press the
RUN/PROG push button LED is on
Namenplate of the bell button module ON (or OFF).
Programming mode of the system is switched off.
1) If there sounds a Progsperr tone instead, a programming lock at the front-door station is activated. The
programming lock can only be deactivated with a Service Device TCSK-01 or the configuration software
configo
TM
.
