01/2013
7
TCS TürControlSysteme AG, TCS Hotline Deutschland: [email protected]
Subject to technical changes.
www.tcsag.de
PI_AMI1090x-uk 1A
2a
Via voice connection
oder
Establish voice connection to
the front-door station
Shortly press the button,
positive acknowledgement
... a ring tone sounds at the front-door
and indoor station
1)
2b
alternatively
: via floor push button
(indoor station is not available)
+
Shortly press the floor push
button two times, every time
a ring tone sounds
Shortly press the button,
positive acknowledgement
... a ring tone sounds at the front-door
station and at the indoor station
1)
Repeat the steps until all bell buttons are programmed.
3
End
Power supply and control unit
or
Shortly press the:
RUN/PROG push button LED is on
Nameplate of the bell button module ON (or OFF).
Programming mode of the system is switched off
1) If there is no response, the programming lock of the bell button module is activated. The programming
lock can only be deactivated with a Service Device TCSK-01 or the configuration software configo
TM
.
Programming a second indoor station to a bell button
If two indoor stations are to be called by pressing one bell button, the serial number of the
second indoor station can be allocated additionally to this bell button.
Note:
A repeated programming of an already programmed bell button changes only the second
serial number.
