新建文件夹
(3)Test and Alignment Specification for NT63
Series (v0 01) 170612
Page 10 of 25
MAC can be set using UART commands described on enclosed SIACP requirements (rev. v3.9).
- Writing MAC command <
0xB3
>, Data length <
6
>, Data type <
HEXA
> (see below command example from above
MAC code)
<
AA 0B B3 5C 36 B8 A8 9D CC 36 78
>
See Appendix
⑼
“
How to upgrade MAC Address using USB
”
▪
Device ID (DID)
Purpose is to allow Other Newtork Download (OND) and further specific Services via dedicated abroad portal (UK
tbc).4 At final, when TV may ask for portal connection, there’ll be Device ID matching control sent by host (TV client)
to ensure total integrity.
For such, specific DID (40 bytes) needs to be paired and overwritten into memory for internal client encryption.
All DID and MAC codes have to be download from portal local service via suitable factory workstation LAN system.
Then during production lot, it’s necessary to send/write all those codes to each TV.
DID codes can only be set using UART commands described above on enclosed SIACP requirements (rev. v3.9).
- Writing Device ID command <
0xB2
>, Data length <
32
>, Data type <
ASCII
> (see below command example from
above DID code)
<
AA 25 B2
42 45 34 46 32 35 35 42 42 44 31 30 36 42 43 38 46 38 30 36 41 45 34 35 36 33 35 30 44 39 31 46
48
93
>
▪
LAN Test
A rough LAN test can be done by conne
cting DHCP server to TV’s RJ45 and check that IP, subnet mask, DNS, …
addresses are visible on
“
Settings
Network
Internet connection(On)
IP settings
”.
More in-depth test can be performed faster using suitable UART/IR commands following SIACP requirements. SW
will internally manage Network ID (NID) flag controlling all MAC/DID/UID integrity to facilitate PA screening further.
See Appendix
⑽
“
Network Connection Setup
”
See Appendix
⑾
“
How to upgrade Flash SW using Network
”
Note
③
:
It’s not necessary to check video and audio from DLNA server.
