TC Electronic FireworX, User Manual

Page: 28 / 83

Select “Tool” and
press Enter
Total amount of
DSP power used
“Tool” Selected
The Mem page
28
EFFECTS SETUP
Effects
The Layout page
The Layout page features a number of functions that all refer to
the Routing. In the Layout display, there is a miniature version of
the current Routing, showing the size of the grid and the position
of the blocks.
Grid Size
The vertical size of the grid can be changed using this parameter.
Dial the Value wheel to set the number of Rows you desire and
press Enter to confirm.
NOTE: If the blocks are located outside the grid, they will be
disabled. However, they will still be present if the grid size is
expanded again.
Columns and Rows
The function of the Columns are somewhat similar to the
function of a spreadsheet. Use these functions when you want to
move, insert or delete a whole Column or Row.
Column
Move Left - Will move the current Column to the Left.
Move Right - Will move the current Column to the Right.
Insert Col - Will insert a new Column.
Delete Col - Will delete the current Column.
Row
Move Up - Will move the current Row up.
Move Down - Will move the current Row down.
Insert Row- Will Insert a new Row.
Delete Row- Will delete the current Row.
Press Enter to carry out the selected function.
The Tool page
The Tool page offers a number of different readouts and shortcuts
to parameters that can be used in the Edit page on each block.
Select the information/function that you desire using the
Parameter wheel and press Enter to confirm.
The Tools can be bypassed in the Edit page by pressing the Exit
key.
In Meter - Mix
Will show the Input level in each block and when a block is
cursor highlighted, the Mix parameter will be instantly adjustable
via the Value wheel. The current setting of the Mix parameter
will be shown in the lower left corner of the Edit page.
In Meter - In level
Will show the Input level in each block and when a block is
cursor highlighted, the In level parameter will be instantly
adjustable via the Value wheel. The current setting of the In level
parameter will be shown in the lower left corner of the Edit page.
In Meter - Out level
Will show in the Input level in each block and when a block is
cursor highlighted, the Out level parameter will be instantly
adjustable via the Value wheel. The current setting of the Out
level parameter will be shown in the lower left corner of the Edit
page.
DSP Load
Will show the percentage of DSP power used in each block, and
the total amount of DSP power used will be shown in the lower
left corner of the Edit page.
Channel Routing
Will show how left/right is routed through each block.