20
Models 8752 & 8756 with Horizon
®
Pump
Operating Procedures
Slide the o--rings into the grooves on the prime plug(s).
Apply an even coat of lubricant to the o--rings and
shaft(s).
Figure 15
Note:
There are two prime plugs for the Model 8756
door, one for each freezing cylinder.
Insert the prime plug(s) into the hole(s) at the top of the
freezer door(s) and push down.
Figure 16
Step 4
Install the freezer door(s). Insert the baffle rod(s)
through the beater(s) in the freezing cylinder(s). With
the door seated on the freezer studs, install the
handscrews. Tighten equally in a criss--cross pattern
to insure the door is snug.
Note:
On the Model 8756, the short handscrews go
on the bottom and the long handscrews go on the top.
Figure 17
Step 5
Install the draw valve(s). Slide the two o--rings into the
grooves on the draw valve(s).
(
Model 8756 Only:
Slide the o--ring and the “H” ring
into the grooves on the center draw valve.)
Lubricate the o--rings.
Figure 18
Summary of Contents for Horizon 8752
