Taylor C723, Operator'S Manual

Page: 38 / 56

6-6
OPERATING PROCEDURES
Model C723
Operating Procedures
6
3. While the solution is flowing into the freezing cylinder,
take particular care to brush-clean the mix level
sensing probe on the bottom of the hopper, the mix
hopper, the mix inlet hole, the mix feed tube, and the
agitator (factory-equipped agitator machines only).
Figure 6-22
4. Prepare another pail of approved 100 ppm sanitizing
solution (examples: 2-1/2 gal. [9.5 L] of Kay-5® or

2 gal. [7.6 L] of Stera-Sheen®). Use warm water and
follow the manufacturer's specifications.
5. Pour the sanitizing solution into the mix hopper.
6. Brush the exposed sides of the hopper.
7. Place the power switch in the ON position.
8. Press the Wash symbol . This will cause the
sanitizing solution in the freezing cylinder to agitate.
A 5-minute countdown timer will display on the
control to show when 5 minutes has elapsed. After
the 5 minutes, proceed to the next step.
Figure 6-23
9. With an empty pail beneath the door spouts, raise the
prime plug.
10. When a steady stream of sanitizing solution is flowing
from the prime plug opening in the bottom of the
freezer door, open the draw valve. Momentarily open
the center draw valve to sanitize the center door
spout. Draw off the remaining sanitizing solution.
11. Once the sanitizer stops flowing from the door spout,
press the Wash symbol and close the draw valve.
Note: Make sure your hands are clean and
sanitized before proceeding to the next step.
12. Lubricate the feed tube O-rings on the end with the
small hole on the side. Stand the feed tube in the
corner of the hopper.
13. Factory equipped agitator machines only: Place
the agitator on the agitator driveshaft housing.
Figure 6-24
Note: If the agitator should stop turning during normal
operation, with sanitized hands, remove agitator from
agitator driveshaft housing and brush-clean with
sanitizing solution. Install the agitator back onto the
agitator driveshaft housing.
14. Repeat these steps for the other side of the machine.
Priming
Note: Use only fresh mix when priming the freezer.
1. Place an empty pail beneath the door spouts. With
the prime plug in the up position, pour 2-1/2 gal.

(9.5 L) of fresh mix into the mix hopper and allow it to
flow into the freezing cylinder.
2. Open the draw valve to remove the sanitizing
solution. When only fresh mix is flowing, close the
draw valve.
12081
13925
12182