6-14
OPERATING PROCEDURES
Model C302 NPR
Operating Procedures
6
6.
Remove the ice buster and prepare to remove the
draw handle.
Important! The draw valve is under pressure from
the spring. Apply downward pressure on the draw
valve while removing the draw handle. After the draw
handle is removed, slowly release the pressure on
the draw valve.
7.
Remove the draw valve, spring, front bearing, and
gasket. Remove all O-rings.
8.
Discard all O-rings and replace with new ones.
Note: To remove O-rings, use a single-service towel
to grasp the O-ring, and apply pressure in an upward
direction until the O-ring pops out of its groove. With
the other hand, push the top of the O-ring forward
until it rolls out of the groove and can be removed
easily.
9.
Thoroughly brush clean all disassembled parts in the
cleaning solution, making sure all lubricant and syrup
is removed. Place all the cleaned parts on a clean,
dry surface to air dry.
10. Repeat step 1 through step 9 for the other side of the
unit.
11. Wipe clean all the exterior surfaces of the unit.
Summary of Contents for C302NP
