Taylor C302NP, Operator'S Manual

Page: 14 / 54

3-2
SAFETY
Model C302 NPR
Safety
3
power leads become taut before the ground
lead can break loose.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
distributor for service.
WARNING! Avoid injury.
• DO NOT allow untrained personnel to operate
this machine.
• DO NOT put objects or fingers in the door spout.
• DO NOT operate the machine unless all service
panels and access doors are fastened with
screws.
• DO NOT remove the machine door or beater
assembly unless the control switches are in the
OFF position.
WARNING! This machine is pressurized when
in operation. The control switch must be in the OFF
position until the machine is completely assembled. No
part should ever be removed from the machine while it is
in operation. No parts should be removed until the control
switch has been turned to the OFF position.
• DO NOT allow untrained personnel to operate this
machine.
• DO NOT operate the freezer unless all service panels
and access doors are restrained with screws.
• DO NOT remove any internal operating parts
(example: freezer door, beater, scraper blades, etc.)
unless all control switches are in the OFF position.
Failure to follow this instruction may result in severe
personal injury from hazardous moving parts or from the
impact of propelled parts.
WARNING! This machine has many sharp
edges that can cause severe injuries.
• DO NOT put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
• USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very
sharp.
Failure to follow these instructions can result in personal
injury or damage to the machine.
CAUTION! This machine must be placed on a
level surface. Failure to comply may result in personal
injury or machine damage.
WARNING! Only install this machine in a
location where its use and maintenance is restricted to
trained personnel. Failure to comply may result in
personal injury.
NOTICE! Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please refer
to the cleaning section of this manual for the proper
procedure to clean this machine.
WARNING! Asphyxiation Hazard!

If used with CO
2
(Carbon Dioxide) or N
2
(Nitrogen),
always make sure the area is well ventilated.

Vent exhaust gas to outside atmosphere using a hose.

Failure to do so can cause serious injury.
CAUTION! This machine is designed to
maintain product temperature under 41°F (5

C). Any
product being added to this machine must be below 41

F
(5

C). Failure to follow this instruction may result in
health hazards and poor machine performance.
Do not run the unit without product. Failure to follow this