Taylor C302NP, Operator'S Manual

Page: 41 / 54

OPERATING PROCEDURES
6-13
Model C302 NPR
Operating Procedures
6
7. Press the BEATER (- - -) key to agitate the solution in
each freezing cylinder for five minutes.
Figure 6-38
8. With a pail beneath the door spouts, open the draw
valves and drain all the solution from the freezing
cylinders. Press the OFF (<- -) key and close the
draw valves.
9. Repeat step 1 through step 8 for the other side of the
machine.
Disassembly
CAUTION! DO NOT remove the machine
door or any internal operating parts (examples: beater,
scraper blades, etc.) unless all control switches are in the
OFF position. Failure to follow these instructions may
result in severe personal injury from hazardous moving
parts.
Remove the following parts from the freezer and take
them to the sink for brush cleaning: handscrews, freezer
doors, baffle assemblies, beater assemblies and scraper
blades, drive shafts, hopper covers, the front drip tray,
and the splash shield.
Brush Cleaning
1. Prepare a sink or a pail with an approved cleaning
solution. Use warm water and follow the
manufacturer's specifications (examples: Stera
Sheen
®
or Kay-5
®
).
Important! Follow the label directions. Too strong of
a solution can cause parts damage, while too mild of
a solution will not provide adequate cleaning. Make
sure all brushes provided with the freezer are

available for brush cleaning.
2. Return to the freezer with a small amount of cleaning
solution. With a single-service towel, wipe clean the
rear shell bearing surface. Brush clean the rear shell
bearings at the back of the freezing cylinders with the
black bristle brush.
Figure 6-39
3. Remove the O-ring and seal from the drive shaft, and
remove the O-ring and bearing from the baffle
assembly.
4. Remove the draw valve handle pin from the freezer
door.
5. Turn the door upside down and install the draw
handle on the other side of the door. Move the draw
handle to the forward position to allow removal of the
ice buster.
Figure 6-40
13039b
10617
101606