Taylor 811 series, Operator'S Manual

Page: 30 / 58

6-8
OPERATING PROCEDURES
Model 811, 813, 819, 821 Series
Operating Procedures
6
Standby Alert Time Key
This is a programmable timer that can be set from 5 to 60
minutes. After the selected time has expired, an alert will
sound and the screen will display PUT INTO STANDBY.
Once the standby alert has sounded, it will take three
Standby button presses to bring the platen down into the
Standby position. The first button press will clear the
alert, and the next two presses will actually bring the
platen down into the Standby position. Button presses
should be done at approximately one-second intervals.
Note: If the button presses are done too quickly, the
platen will come down and initiate a cook cycle instead of
placing the platen into Standby. Pressing the Raise
button will cancel the cook cycle.
Loading Store Menu Items to USB
The same USB flash drive that was used to load software
into the grill can be used to perform this procedure.
1. Remove the USB cap from the USB connector to
access the USB port.
2. Insert the USB flash drive into the USB port.
3. Press and hold the PROGRAM key for 5 seconds to
enter the Program mode.
Figure 6-21
4. Enter the operator password STORE 1 and press the
OK key.
Figure 6-22
5. Press the MENU EDIT key.
Figure 6-23
6. Press the STORE MENU TO USB key.
Figure 6-24
13733
131020
131021
131023