Taylor 811 series, Operator'S Manual

Page: 24 / 58

6-2
OPERATING PROCEDURES
Model 811, 813, 819, 821 Series
Operating Procedures
6
4. Place the release sheet clips over the release sheet.
Press them into place over the release sheet bar at
the top of the platen.
Figure 6-4
Note: The release sheet should be tight to the platen
with no visible wrinkles or gaps. If the sheet is not
tight or has wrinkles, it can affect the cooking of the
product.
5. Repeat steps 1 through 4 for the remaining upper
platen(s).
Note: Temperature checks should only be

conducted with the release sheets removed.
Replacing the release sheet:
• Cleaning procedures fail to remove all buildup and
product sticks to the release sheet.
• A tear appears in the cooking area of the release
sheet, causing product to stick to the release sheet.
Figure 6-5
CAUTION! The upper platen surface and
release sheet are very hot. To prevent burn injuries, wear
heat-resistant gloves when replacing the release sheets.
Note: It is not necessary to change the release sheet if
small pin holes develop on the sheet.
Care of Release Sheets
Do not:
• Do not fold or crease.
Figure 6-6
• Do not touch with sharp objects, grill scrapers,
or abrasive pads.
• Do not place under other equipment or objects.
• Do not hot-hose or soak in water.
Do:
• Do clean with a squeegee after each run of
product.
• Do wipe with a clean, sanitizer-soaked grill cloth
a minimum of four times per hour and more
often during peak periods.
• Do clean daily on both sides, using an approved
high temperature grill cleaner and the grill
cleaning pad and holder identified on page 4-6.
IMPORTANT! Clean the release sheets using
the only grill cleaning pad and holder identified on
page 4-6. Using any other pad and holder will damage
the release sheets.
14352
14361
14353
!