![background image](http://html1.mh-extra.com/html/taylor-dunn/tt-416/tt-416_operators-manual_3773864046.webp)
Page 46
TT-416 Stand Up Tow Tractor
MT-416-00
•
Refer to battery warnings at the start of this chapter.
•
Use the proper equipment when handling and transporting batteries. Equipment
that is used to lift and support batteries should be rated at a minimum of 1.5 times
the total battery weight.
•
Keep all body parts out from underneath any battery that is not installed and latched
in the vehicle.
Failure to follow these rules may result in severe bodily injury and/or property damage.
WARNING
Side Extract Battery
Remove
8. Remove the battery door.
9. Disconnect the battery cable.
10. Using a winch or other powered device, pull the battery out of the vehicle and onto the
battery storage platform.
Install
1.
Confirm the start switch is OFF.
2. Ensure the vehicle is as close as possible to the battery storage platform.
3. Place battery next to vehicle on the platform.
4. Push the battery all the way into the compartment.
5. Install the battery door.
6. Connect the battery cable.
Transporting the Battery
Before removing the battery:
1) Refer to battery warnings at the start of this chapter.
2) Park the vehicle on a level surface.
3) Position the vehicle as close as possible to the platform where the battery will be stored.
4) Place the Directional Control switch in the center OFF position.
5) Make sure the Start switch is in the OFF position.
6)
Confirm park brake is applied.
7) Block the wheels.
WARNING