Taylor-Dunn SC 0-90, Operation, T Roubleshooting And Replacement Parts Manual

Page: 49 / 130

Maintenance, Service, and Repair
Brake Service
Page 5
Wheel Park Brake
The parking brake is actuated through the same linkages as the service brake. Refer to
Inspect the
Service Brake
section to inspect the brake pads.
If any sign of damage or wear is found on the park brake handle,
cables, or linkages then they must be repaired or replaced immediately.
Failure to repair or replace any damaged component could result in
failure of the park brake causing severe bodily injury and/or property
damage.
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
6. Inspect all brake cables and linkages for any signs of damage or missing cotter pins.
7. Inspect the park brake handle for any signs of damage or wear.
8. Set the park brake.
9. Reconnect the main positive and negative cables at the batteries.
10. Remove the blocks from the wheels
INSPECT THE PARKING BRAKE