Taylor-Dunn SC 0-90, Operation, T Roubleshooting And Replacement Parts Manual, Page: 33 / 130

Maintenance, Service, and Repair
Front Axle
Page 5
1. Make sure the key-switch is in the “OFF” position, then remove
the key.
2. Place the forward-reverse switch in the center “OFF” position.
3. Set the park brake.
4. Place blocks under the rear wheels to prevent vehicle movement.
5. Disconnect the main positive and negative cables at the batteries.
Always use a lifting strap, hoist, and jack stands, of adequate capacity
to lift and support the vehicle. Failure to use lifting and support devices
of rated load capacity may result in severe bodily injury.
REPLACE FRONT WHEEL BEARINGS
6. Remove the front axle and wheel(s). Refer to
Front Axle Removal and Installation
section
for information regarding removing the axle.
7. Remove the spacers, seals and bearings from the hub
8. Thoroughly clean all grease from the inside of the hub and the bearings.
9. Drive the races out from the hub.
10. Press new races into the hub.
11. Assemble in reverse order, using new grease seals.
a. Pack bearings with grease.
b. Refer to
Front Axle Removal and Installation
section for information regarding installing
the axle.
12. Lower the vehicle.
13. Reconnect the main positive and negative cables at the batteries.
14. Remove the blocks from behind the wheels.
15. Release the park brake and test drive the vehicle.