Taylor-Dunn MB-238-00, Operation, T Roubleshooting And Replacement Parts Manual

Page: 97 / 194

Maintenance, Service, and Repair
Suspension
Page 3
REPLACE THE SPRING
BUSHINGS (REAR ONLY)
It is recommended that both left and right side spring
bushings are replaced as a set.
Complete the procedure for one side before replacing
the opposite side bushings.
6. Remove the spring
eye bolt and spring u-
bolt.
1. Make sure the key-switch is in the “OFF”
position, then remove the key.
2. Place the forward-reverse switch in the
center “OFF” position.
3. Set the park brake.
4. Place blocks under the front wheel to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.
Always use a lifting strap, hoist, and jack
stands, of adequate capacity to lift and
support the vehicle. Failure to use lifting
and support devices of rated load capacity
may result in severe bodily injury.
7. Raise the rear left or right side of the vehicle
depending on which side bushings are to be
replaced and support with jack stands.
8. If the spring eye did not fall out of the frame tabs,
pry the spring out of the frame with a pry bar.
9. Remove the spring bushings.
10. Install the new bushings in reverse order.
HINT: Apply a light coating of grease to the bushing
before pressing into the spring eye.
11. Install the spring eye bolt and u-bolt.
12. Lower the vehicle.
13. Reconnect the main positive and negative cables
at the batteries.
14. Remove the blocks from behind the wheels.
15. Release the parking brake and test drive the
vehicle.