Taurus ALPATEC AC 3100 KT, Manual, Page: 21 / 176

CLEANING
- Wipe the appliance with a damp cloth impreg-
nated with a few drops of detergent. Do not use
solvents or products with an acidic or basic pH
factor such as bleach or abrasive products to
clean the apparatus.
- Do not immerse the connector in water or other
liquid or place it under the tap. If the appliance
is not maintained in good condition
- Cleaning, its surface can be degraded and inex-
orably affect the life of the appliance and lead to
a dangerous situation.
CLEANING THE AIR FILTER:
- Clean the air filters every 2 weeks. If the air
filter is blocked with dust, its effectiveness will
be reduced.
- Washing the air filters by submerging them
- Carefully in warm water with a neutral deter-
gent, rinse them off and let them dry completely
in a shady place.
- Install the filters carefully after having them
cleaned.
AFTER PERIODIC MAINTENANCE:
- Switch off the appliance and remove the plug.
- Separate the exhaust pipe from the air and
store it carefully.
- Put the appliance in a dry place.
- Remove the batteries from the remote control
and store them carefully.
ANOMALIES AND REPAIR
- In the event of a fault, take the appliance to an
authorized service center. Do not attempt to dis-
assemble or repair it as there may be danger.
- Any person who is involved with working on or
breaking into a refrigerant circuit should hold
a current valid certificate from an industry-ac-
credited assessment authority, which authorizes
their competence to handle refrigerants safely
in accordance with an industry recognized
assessment specification.
- Servicing shall only be performed as recom-
mended by the equipment manufacturer. Main-
tenance and repair requiring the assistance
of other skilled personnel shall be carried out
under the supervision of the person competent
in the use of flammable refrigerants.
- If any fault is detected, refer to the following
table:
Problem Causes Solutions
Product is not working No llega corriente.
Indicador de llenado de agua
iluminado
Switch on device
Empty water tank
Start device after empty water tank
Seems device is not
working
Windows or doors are open
Dirty filter
Air inlet or outlet are block
Room temperature is lower
than the programated
Close courtains
Close windows
Clean or change air filter
Clean container
Change temperature setting
Devide noise too loud Device is not in a flat surface Change device in a flat surface
Compressor is not
working
Overheat protection is activa-
ted
Switch on device after 3 minutes, when
temperature is lower
Detection codes Meaning
E0: Temperature sensor problem
E2/E4: Water tank full