APX-03 Keypad & Proximity Reader Programming Instructions
Additional Programming functions
Example
Indication
1
Enter into Programming mode as shown on page 4.
2 Enter Function code 48 then EN
FUN 48 EN
OK indicator flashes
3 Enter 0 then EN to clear data
0 EN
Bleep followed by several chirps
To Clear all Code & Fob data:
After a few seconds the keypad will go into the Initial Power up sequence so you will need to re-program the
Lowest Fob number as the Master Fob again (see Initial Power up). All Code & Fob data is now deleted.
8
CARD TYPE
EM
FREQUENCY
125KHz
MAXIMUM FOB READING RANGE
110mm
MAXIMUM NUMBER OF FOBS
12,000 (20 BATCHES OF 600 CONSECUTIVE No'S)
MAXIMUM NUMBER OF CODES
FIVE 4 DIGIT USER CODES
NUMBER OF DOORS
ONE
DIGITAL OUTPUTS
TWO VOLTAGE FREE RELAYS (Max 24v DC @ 1A)
INDICATION
3 LIGHTS (POWER / OK / ERROR)
BACKLIGHTING
ALL BUTTONS (GREEN)
HOUSING MATERIAL
PC + ABS
OPERATING TEMPERATURE
-20 deg C to 55 deg C
STORAGE TEMPERATURE
-25 deg C to 85 deg C
POWER REQUIREMENTS
12 Volts DC +/- 10% (Min 300mA)
LOCK SUPPRESSION DEVICE
CAPACITOR 474J 100JS
DIMENSIONS
Width 81mm x Height 123mm x Depth 21mm
SPECIFICATIONS:-
Instructions for Adding a Master Fob when original Master Fob is Lost
To Program a new Master Fob when the original has been lost you will need to remove the Front Cover of the
Keypad and look for a label in the top right corner showing an 8 digit number (if there is no label you will need to
remove the unit from the wall and look on the back for a label with a Barcode and 12 digit serial number).
Make a note of the 5th to 8th numbers (4 digits). Note: All other Code and Fob data will remain the same.
Indication
1
Power indicator will go out
2
All 3 indicators flash once then Power indicator
lights followed by a Long Bleep then Short Bleep.
3
OK indicator will start flashing
4
All 3 indicators will light up followed by 2 Long
Bleeps then a Short Bleep.
5
Long Bleep and OK indicator flashes once
Note: When adding a New Master Fob we recommend the next lowest number fob is used.
Enter the 4 digit number from the Keypad label then EN
When the Error & OK lights start flashing present the Fob you
want to add as a New Master Fob within 10 seconds.
To Add a New Master Fob when Original is Lost:
Switch the Power Off to the Keypad for 30 Seconds.
Switch Power on and wait for the Keypad to respond
Immediately after the Short Bleep enter MENU then EN
Web: www.tatecolson.co.uk E-mail:[email protected] Tel: 01704-502801 Fax: 01704-502810
