90
I25
I24
I23
I22
I21
I20
I19
I18
I17
I16
tr
sv
sl
pt
pl
no
nl
it
fr
fi
es
en
de
da
cz
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in sev-
eral work steps.
Replenishing cleaning solvent
Draining dirty water
Recovery tank full display:
End of operation
Manual process
Automatic process
Removing and cleaning the squeegee
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
This effect can be reduced by special
wheel options.
Attention:
The flooring may be damaged when
working without cleaning solution.
Notice:
A rattling noise from the pump indicates an
empty fresh water tank (Flextank).
Attention:
The pump must never run dry for an
extended period.
• The machine must be switched off.
• Open the tank lid.
• Fill water into the fresh water tank (Flextank), see page 87.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
• If the Recovery tank display lights up, the
cleaning program is interrupted, the squee-
gee is lifted and the suction unit is switched
off.
• Drain the recovery tank, see page 91.
Notice:
In case of frothing in the tank, the recovery
tank display also lights up.
• Drain the recovery tank, see page 91.
• Press the Cleaning solution ON/OFF
button.
The cleaning solution supply is stopped.
• Drive on for some meters so that the brushes keep on
rotating for a short time to avoid dripping.
Very important for TASKI contact pads!
• Press the Brush drive ON/OFF button.
The display lights up and the brush unit is
stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the Suction unit ON/OFF
button.
The display lights up and the squeegee is
automatically lifted.
The suction motor is still on for 15 seconds.
• Press the Program start/stop button.
The cleaning solution supply is stopped.
The brush unit is stopped and lifted.
After 30 seconds, the squeegee is lifted.
The suction motor is still on for 15 seconds
until it is automatically switched off.
• The machine must be switched off.
• Remove both suction hoses from the squeegee nozzles.
• Compress the position locks. The
squeegee is released and can be re-
moved from the squeegee holder.
• Clean the squeegee under running water using a brush.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
