87
Relocation drive
The direction of travel is controlled by the handle bar and the
speed by the driving switches. The speed is continuously
regulated.
When the driving switch is released, the machine is
decelerated until it stops and the parking brake is activated.
Brush installation
Check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
XP-R
XP-M
Squeegee assembly
Filling the fresh water tank
• Switch on the machine (key switch).
The display lights up briefly.
The battery level indicator notifies you that
the machine is ready for operation.
(In case of malfunctions, please see
page 93).
• To move forward simply push the driving
switches forward.
• To move backwards push the driving
switches backward.
Notice:
The speed is electronically reduced for
cornering.
Notice:
The squeegee is automatically lifted and
the cleaning solution supply is interrupted
for reversing during operating mode.
Attention:
Do not use brushes which have reached
their wear limit.
The wear limit is indicated by the length of
the red bristle.
Do not use pads which are worn out or
dirty. Use original TASKI brushes only.
Failure to observe these instructions may
result in inadequate cleaning results or
even floor damage.
• Position the brushes under the brush unit.
• Press the Brush drive ON/OFF button.
The brush unit is automatically lowered,
centers the brushes and stops.
• Stand on the running board.
• Press the Brush drive ON/OFF button.
The brushes are engaged and the brush unit
is lifted.
Attention:
Check whether the brushes are engaged.
Notice:
The brush drive is activated by pressing
the driving switch.
• Push the brush up and insert it until it
engages.
• The machine must be switched off.
• Put the squeegee under the squeegee suspension.
• Position the squeegee under the
shackles of the squeegee holder (1)
so that they fit into the recesses of
the squeegee (2).
• Press down the squeegee holder
until the squeegee engages.
• Firmly attach both suction hoses to the sockets of the
squeegee.
Attention:
Max. permissible water temperature
60 °C/140 °F.
Diversey recommends using cold water
since hot water will adjust to the floor
temperature as soon as it is in contact with
the floor. Thus there are no advantages to
using of hot water.
• The machine must be switched off.
• Open the tank lid.
• Put the fresh water tank (Flextank) onto the provided
fixture.
• Take the dosing cup from the fresh water tank (Flextank).
• Fill water into the fresh water tank
(Flextank).
The upper red marking indicates the
max. permissible filling level.
click
1
1
2
2
