+
Configure
1X = Disable
2X = on without Lock
3X = On and lock
4X = On and lock
Off and lock
+ +
IGNITION
ON
START
OFF
MASTER
DOOR OPEN
Select the Beep 16 function
Taramps reserves the right to change the contents of this manual without prior notice or obligation to apply the
modifications to previously produced units.
• Scratched or torn warranty seal;
TARAMPS, located at Rua Abílio Daguano, 274 Res. Manoel Martins - Alfredo Marcondes - SP, ZIP19.180-000, guarantees this
product against design, manufacturing, assembly and/or joint and several defects due to design flaws tha make t it
unsuitable or inappropriate for its intended use, for a period of 24 months from the date of purchase.In the event of a
malfunction within the warranty period, TARAMPS' liability is limited to repairing or replacing the device manufactured by it.
• Costs for removing and reinstalling the equipment, as well as transporting it to the technical assistance post;
• Products damaged by incorrect installation, water infiltration, tampering by unauthorized persons;
This warranty excludes:
• Defects caused by accessories, modifications or equipment attached to the product;
• The product presents damage resulting from drops, impacts or the action of agents of nature (floods, lightning, etc.);
• Cases where the product is not used under normal conditions;
• Damage of any kind, resulting from problems with the product, as well as losses caused by interruption of use.
• Natural wear components: such as battery;
WARRANTY TERM
Taramps Electronics
- Rua: Abílio Daguano, nº 274 - ZIP19.180-000
Factory technical assistance department:
E-mail: [email protected]
Fones: +55(18) 3266-4050 / 99749-3391
To change, press the Master key the number of times referring to the desired
function. Each time you press the Master, the alarm confirms with 1 beep. After
turning the ignition,off the alarm will confirm the new setting with beeps.
+
MASTER
Programming by Master
1 Beep
= Disabled
2 Beeps
= Turns on the alarm without locking
- With the door open, turn on the ignition.
3 Beeps
= Turns on the alarm and lock
- The alarm responds with the current setting:
4 Beeps
= Turn On and Lock / Turn Off and Unlock
- Hold the master pressed until beep 16.
14) Turn Alarm on by Distancing
This function is used to turn on the alarm only when pulling the TR2-P G4 remote control away
from the vehicle. After turning the ignition off, opening and closing the vehicle door, and
moving the control beyond the transmission range, within 15 seconds the alarm will turn on.
According to the setting, the alarm will:
1st Beep =
Disabled, the alarm will only turn on/off when pressing the control buttons.
2nd Beep =
Turns the alarm on when moving the control away without locking the doors, it
will only turn off the alarm when pressing the control Off button.
3rd Beep =
Turns on the alarm when moving the control away and locks the doors, it will only
turn off the alarm and unlock the doors when pressing the control's Off button.
4th Beep =
Turns on the alarm when moving the control away and locks the doors. Turns off
the alarm and unlocks the doors by pressing the control's Off button or by bringing the TR2-P
G4 control closer to the vehicle and waiting for the automatic transmission.
14
ATTENTION: EXCLUSIVE function of the G4 line with TR2-P G4 control.
