- With the door open, switch on the ignition.
To exit setup, turn off the ignition.
Simultaneously press the ON + OFF keys, the alarm will sound 3 Beeps
confirming the recording.
It is possible to record up to 4 controls, when recording the 5th the
first one will be erased.
- When releasing, the alarm will sound1 long beep and the turning
signals will be on.
PROCEDURE:
- Hold the master pressed until beep 3.
Register NEW control in the Alarm Central
+
+
IGNITION
ON
START
OFF
MASTER
DOOR OPEN
3 beeps
Change code G3 / G4 - TR2 and TR2-P controls
A - Hold pressed the Home and Auxiliary keys;
B - Release after the LED goes out;
4 flashes= G4 line onwards
C - The LED will flash informing the new code system:
3 flashes= line G1 to G3
Change G3 / G4 code - TR3C and TR4C controls
A - Hold pressed the Power off and Auxiliary keys;
B - Release after the LED goes out;
C - The LED will flash informing the new code system:
3 flashes= line G1 to G3
4 flashes= G4 line onwards
ATTENTION: Function only exists in
controls manufactured from June/2019.
ATTENTION: Function only exists in
controls manufactured from June/2019.
4) Remote Controls*
Ÿ
Operating Frequency 433.92MHz
Ÿ
Anti-Cloning Technology (Hopping Code)
Ÿ
Anti Jammer Transmission System
Ÿ
1 3V Battery - CR 2032 LITHIUM
Images
for
illustrative
purposes
only
, and
may
differ
from
the
real
image!
*See item 3 to check which remote control belongs to which Alarm model.
Any control model can be purchased separately.
‘‘‘‘This equipment operates on a secondary basis, that is, it is not entitled to
protection against harmful interference, even from stations of the same type,
and may not cause interference to systems operating on a primary basis.’’
Replacing the Control Battery.
USE A HIGH QUALITY
BATTERY
(-).Use CR2032 batteries.
Carefully open the plastic box from
the sides.Replace the battery,
observing the polarity (+) and
BUTTONS
HOME
Tr2
Control
TR2-P
PRESENCE
CONTROL
02
Controls Functions
(Manufactured from June 2019)
Jammer is when there is another control transmitting near the alarm center,making it impossible to
turn the alarm on or off by the registered control.
- Code G4 (exclusive for the TW20 G4 line).
- Anti Jammer function. EXCLUSIVE IN THE G4 TARAMPS LINE.
- Code G3 (for the TW20 G1 to G3 line).
ON OFF AUXILIARY
