13
Activate Auxiliary Outputs 2
- Press and hold the OFF key on the control with the ignition off
and the alarm off.
+ than 3
seconds
- With the door open, turn the ignition on.
5 Beeps
= Auxiliary Output 2
- Hold the master pressed until beep 13.
- The alarm responds by informing the current setting:
1 Beep
= Reads negative switch
2 Beeps
= Lê interruptor Positivo
Programming by Master
3 Beeps
= Open / Close Automated Gate
4 Beeps
= Reads Headlight On/Off
Auxiliary Output 2 Setup- brown wire
3) Open / Close Automated Gate.
To install on door switch, hood or trunk with Positive signal ,when open.
5) Auxiliary Output 2
To install on a door switch, hood or trunk with a Negative signal, when open.
It is used to lower electric windows for example.
4) Headlight Warning On/Off.
When turning the ignition off and opening the door with the headlight on, the alarm sounds a
long beep.
Using an Auxiliary Relay is required.
2)Reads Positive switch.
1) Reads Negative switch.
After 10 seconds with the ignition on, the ultrasound LED will be flashing, warning that the
headlight is off, turning on the headlight ,the LED goes out.
To change, press the Master key the number of times referring to the desired
function. Each time you press the Master, the alarm confirms with 1 beep. After
turning the ignition off , the alarm will confirm the new setting with beeps.
+
MASTER
+
Configure
1X =
Door
-
2X = Door
+
3X = Gate
4X = Headlight
5X = Auxiliary 2
+ +
IGNITION
ON
START
OFF
MASTER
DOOR OPEN
Select the Beep 13 function
Exclusive function for the TW30 model
Exclusive function for the TW30 model
