Technical Specification
Reference Guide: EN8000 MPEG-4 Part 10 (H.264/AVC) Encoders
Page B-17
ST.RE.E10233.1
B.7.2 EMC
2
The equipment has been designed and tested to meet the following:
EN 55022
and
CISPR22
European
International
Emission Standard
Limits and methods of measurement of radio
frequency interference characteristics of
information technology equipment - Class A.
EN 61000-3-2
3
European
Electromagnetic Compatibility (EMC), Part 3
Limits; Section 2. Limits for harmonic current
emissions (equipment input current
≤
16 A per
phase).
EN 61000-3-3
European
Electromagnetic Compatibility (EMC), Part 3.
Limits; Section 3. Limitation of voltage fluctuations
and flicker in low voltage supply systems for
equipment with rated current
≤
16 A.
EN 55024
European
Information technology equipment - Immunity
characteristics - Limits and methods of
measurement.
FCC
USA
Conducted and radiated emission limits for a
Class A digital device, pursuant to the Code of
Federal Regulations (CFR) Title
47-Telecommunications, Part 15: Radio frequency
devices, subpart B - Unintentional Radiators.
The CE mark is affixed to indicate compliance with the following directives:
89/336/EEC of 3 May 1989 on the approximation of the laws of the Member States relating to
electromagnetic compatibility.
73/23/EEC of 19 February 1973 on the harmonisation of the laws of the Member States
relating to electrical equipment designed for use within certain voltage limits.
1999/5/EC of 9 March 1999 on radio equipment and telecommunications terminal equipment
and the mutual recognition of their conformity.
(If fitted with telecom type interface modules).
NOTE...
The CE mark was first affixed to this product in 2006.
B.7.4 C-Tick
Mark
The C-Tick mark is affixed to denote compliance with the Australian
Radiocommunications (Compliance and Labelling – Incidental Emissions) Notice
made under s.182 of Radiocommunications Act 1992.
NOTE...
The C-Tick mark was first affixed to this product in 2006.
2
The EMC tests were performed with the Technical Earth attached, and configured using recommended cables (see
Table B.29
).
3
Applies only to models of the Encoder using AC power sources.