12
Line data input
(With backing line)
9.
Wind on another 100 m of line, keeping line tension at the
suggested level.
8.
When the line length input screen appears, press the
MODE
BUTTON
again to let the back line 1 input screen appear.
With the power lever moved forward,
P2
changes into a tension
indicator. Keep line tension between 4 and 5 while winding.
10.
Press
RESET BUTTON
for 2 seconds.
P2
blinks and the counter in the upper area shows
50
. The
upper counter digits increase as line is wound.
11.
Wind the remaining 50m, keeping line tension at the
suggested level. Do not wind line all the way onto the spool.
12.
Press
RESET BUTTON
for 2 seconds.
The upper counter shows
100
.
13.
Wind the remaining 50m, keeping line tension at the
suggested level.
14.
Press
RESET BUTTON
for 2 seconds and
0.0
will appear.
This is the end of the procedure.
P2
will be blinking.
Attention
14
9
10
12
8
Attention
1.
Do not wind the end of the line onto the spool because it causes incorrect length calculation.
Move the power lever to OFF, and wind manually when nearing the end of the line.
If the line is wound indoors at a low speed and with a high tension for a long period of time
(*1), the motor will be overheated, which may cause motor failure. Tilt the power lever to the
MAX position before inputting a value. This issue does not need to be considered during
fishing because the motor will be cooled by sea water.
(*1) If the line is wound continuously for 10 minutes, the motor overheat prevention function
will start to work, which will stop the motor. In this case, the display will start to blink and any
operation will become unavailable for 5 minutes. When the countdown display on the
chumming timer indicator area reaches “
” (min.), a beep will sound and data
inputting will become available again from the state immediately before the motor stoppage.
If “
Err
” appears in the display, go back to STEP 7 and
re-enter the data again.
P2 Inputting Line Backing
Back line entry screen
RESET
MODE
RESET
MODE
RESET
MODE
RESET
MODE
