10
Attention
1.
Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF position, and wind manually when nearing the
end of the line.
OFF
9
10
12
10.
Press
RESET BUTTON
for 2 seconds, until the display shows
300
. (300 is the default setting)
9.
Pull the lever back to the OFF position, after winding.
11.
Enter the line length with the power lever. (in the figure on the
right, line length is 280 m).
12.
Press
RESET BUTTON
for 2 seconds and a beep will be
heard. The display should return to
0.0
, completing the setting
procedure.
If “
Err
” appears on the display, you must use the
MODE BUTTON
to re-enter the data.
Line data input
(When line length is known)
MAX
OFF
11
Do not reel in the
end of the line
P1 Inputting the line length
RESET
MODE
RESET
MODE
