TAMS MasterControl 40-01007, Manual

Page: 33 / 58

MasterControl English
Page 6.15
Configuring the booste r
Booster
configuration
# / ok
Possible actions:
To navigate to submenu level 2 press # / ok.
Navigate to another menu point in submenu level 1 by turning the
speed control knob.
Go back to the main menu by pressing * / esc.
Short c. pol.
positive (MM)
# / ok
Possible actions:
To change the short circuit polarity press # / ok.
Navigate to another menu point of submenu level 2 by turning the
speed control knob.
Go back to the main menu by pressing * / esc.
Short c. pol.
positive (MM)
Possible actions:
Adjust the short circuit polarity by turning the speed control knob.
Confirm your input by pressing # / ok. You’ll then be taken back
to submenu level 1 and changes are saved.
Cancel with * / esc. You’ll then be taken back to submenu level 1
without saving changes.
Hint:
The use Märklin**-compatible boosters requires setting the short
circuit polarity to „positive” and for DDC-compatible boosters to
“negative”.
Short c. sens.
100 ms
# / ok
Possible actions:
Adjust the short circuit polarity by turning the speed control knob.
Navigate to another menu point of submenu level 2 by turning the
speed control knob.
Go back to the main menu by pressing * / esc.
Short c. sens.
100 ms
Possible actions:
Adjust the short circuit polarity by turning the speed control knob.
Possible values: OFF, 5, 10, 15, ... 1000 ms.
Confirm your input by pressing # / ok. You’ll then be taken back
to submenu level 1 and changes are saved.
Cancel with * / esc. You’ll then be taken back to submenu level 1
without saving changes.
Hint:
The lower the set value, the faster the short circuit detection reacts
and booster outputs are switched off. Please note: A high value can
cause “welding” in case of a short circuit (especially in combination
with a powerful booster).