TAMS MasterControl 40-01007, Manual

Page: 26 / 58

English MasterControl
Page 6.8
CV p rogramming (bitwise)
CV (bit)
# / ok
Possible actions:
To read or change press # / ok.
Navigate to another menu point of the submenu level 1 by turning
the speed control knob.
Go back to the main menu by pressing * / esc.
CV (bit)
CV: 29 Bit:1=1
Possible actions:
Reading a CV bit: Enter CV number and bit number on the keypad
(only possible, if the cursor is centred on the corresponding field)
and confirm input with # / ok. The saved value appears in the
field on the right.
Changi ng a CV: Turn the speed control knob (Cursor moves
towards the CV bit field), enter value with the keypad and confirm
by pressing # / ok.
Go back to the submenu level 1 by pressing * / esc.
Setting p rimary addresses
Primary address
# / ok
Possible actions:
To read or change press # / ok.
Navigate to another menu point of the submenu level 1 by turning
the speed control knob.
Go back to the main menu by pressing * / esc.
Primary address
103
The MasterControl automatically reads the decoder’s address.
Possible actions:
Enter the new address on the keypad and confirm input with
# / ok.
Hint: The CV numbers 1 and 29 are automatically set to “Primary
address”.
Go back to the submenu level 1 without saving changes by
pressing * / esc.
Setting extended add resses
Extend. address
# / ok
Possible actions:
To read or change press # / ok.
Navigate to another menu point of the submenu level 1 by turning
the speed control knob.
Go back to the main menu by pressing * / esc.
Extend. address
10099
The MasterControl automatically reads the decoder’s address.
Possible actions:
Enter the new address on the keypad and confirm input with
# / ok. Hint: The CV numbers 17, 18 and 29 are automatically set
to “extended addresses”.
Go back to the submenu level 1 without saving changes by
pressing * / esc.