Tamas Hydronic Systems Inc.
Page 17
Tamas Hydronic Systems
180° End Connector Assembly
1.
Add silicone grease to the O-ring, a line film of lubrication can assist and
avoiding rolling the O-ring
2.
Position the Z-block and the connection fitting (Part #025-0003) side by
side.
3.
Push firmly in the axial direction until it reaches the end stop.
4.
Repeat the same procedure with the second connection fitting as shown
below.
5.
To enable the bayonet connection between Z-Block modules and the 180
end connection, position the Z-block with the 180 end connection fitting
side by side. Push firmly in the axial direction until it reaches the end stop.
Apply Silicon Grease to O-Rings
on Connection Fitting. a line film of
lubrication can assist and avoiding
rolling the O-ring.
1
2
Insert Connection Fittings
and push until it stops.
Push locking tabs down or up to
seal the connection.
4
3
Align Z-Block and 180° Connector,
and push the Connector onto
Connection Fittings until they stop.
Assembly
