TallyGenicom LGe06, Operator'S Manual

Page: 65 / 108

Chapter 3: Printer Menus and the Control Panel
3–65
TOF Control (Available when Genicom ANSI emulation is selected)
When a new form is defined, the top-of-form position is left unchanged if this
parameter is Enabled (the default). When a new form is defined, and this param-
eter is Disabled, the top-of-form position is reset to the top margin of that form.
DC3 Operation (Available when Genicom ANSI emulation is se-
lected)
This parameter allows DC1 - DC3 operation. When Enabled (default), the printer
can be selected and deselected using DC1 and DC3 control codes. The printer
select/deselect operation is not in effect when Disabled.
SISO OverszBar (Available when Genicom ANSI emulation is se-
lected)
This parameter allows SI-SO operation for bar codes and oversize characters.
When Disabled (default), bar code and oversize character modes do not need to
be activated with SO and deactivated with SI. When Enabled, bar code and
oversize character modes will be activated and deactivated using the SO and SI
control codes.
Barcod Top Pos (Available when Genicom ANSI emulation is se-
lected)
When Enabled (default), the paper position is reset to the top of the bar code
after printing. When Disabled, the paper position is left at the end of the bar code
after printing.
Oversz Top Pos (Available when Genicom ANSI emulation is se-
lected)
The paper position will be reset to the top of the oversize characters after printing
when this parameter is Enabled (default). When Disabled, the paper position is
left at the end of the oversize characters after printing.
Config Menu
⇒
Codes