User guide
The control panel
24
Messages in the LC
display
If the printer detects an internal fault or user error or if it expects you
to do something, a message will appear in the LC display. It also dis-
plays the status during an operation (e.g. Loading default). Below
you will find a list of messages with brief descriptions of each mes-
sage. The messages are described in greater detail in the chapter
Error messages via the display
(page 101).
Message
Meaning
Eject error
The printer cannot eject the paper /
advance it to park position.
Hardware Alarm
Internal hardware error, contact your
dealer or service technician.
Head hot
The printer reports that the print head is
hot and that print speed will be reduced.
Initializing
This message appears during the
printer’s initializing phase.
Load error
The printer cannot draw in the loaded
paper.
Loading default
Indicates that the printer is being initia-
lised and is carrying out the internal self-
test immediately after turning on the
printer. Factory defined parameters will
be reloaded in all available menues.
Out of paper
The printer has detected paper end dur-
ing operation / printer was switched on
with no paper loaded.
Parity error
A parity error during data transmission is
indicated.
Press any key
The user is requested to press any key.
Tear Paper off
The user is requested to tear off paper
which has been advanced to the quick
tear edge.
Selftest
After power-on, the printer executes a
short hardware self-test.
