Jul 07
3-4
45 PPM Laser Printer User Guide
Installing the Hard Disk Option in the Printer
Installing the Hard Disk Option in the Printer
1.
Carefully review the safety precautions in the front of this guide before starting this installa-
tion procedure.
2.
Ensure that the printer power switch is set to the OFF <
O
> position.
3.
Disconnect the power cord from the wall outlet.
4.
Remove the inside panel (see
“Installing DRAM Memory DIMMS”
Figure 3-1).
5.
Locate the area of the controller identified as “Hard Disk”. Ensure that there is a plastic
female insert fitted into the board into which the supplied plastic rivet can be fitted in stage 8.
Align the hard disk within the designated area and gently move up to ensure the 44-pin male
connector of the hard disk is connected to the 44-pin female connector on the controller
assembly.
Figure 3-4.
6.
Be sure to align the Hard Drive as depicted by the alignment drawing on the controller, mak-
ing sure that the two top pins to the left of the connector are free standing and not con-
nected.
Figure 3-5
Summary of Contents for 9045N
Page 1: ...Jul 07 User Guide TallyGenicom 9045N Laser Printer...
Page 29: ...Jul 07 45 PPM Laser Printer User Guide 2 3 Printing a Configuration Summary...
Page 120: ...Jul 07 4 26 45 PPM Laser Printer User Guide When Moving the Printer...
Page 127: ...Jul 07 45 PPM Laser Printer User Guide 5 7 At the Fuser Unit 6 Open and close the top cover...
