Jul 07
2-32
45 PPM Laser Printer User Guide
System Menu
System Menu
The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:
1.
Press the
MENU
button on the control panel.
2.
Press the
NEXT
button until the text
System Menu
is shown on the second line of the dis-
play.
3.
Press the
SELECT
button to enter the system menu.
4.
Press the
NEXT
button to move through the submenus:
Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, Toner
Low, and Intellifilter.
5.
Press the
SELECT
button to enter a submenu.
Use the procedures in the following table to access and change the system settings:
Submenus
Default Setting
Available Settings
Procedure for Changing Setting
Factory Defaults
When selected, this will reset all
operator settings to the factory
default values. Non US sets
measurements to millimeters. US
sets the measurements to inches.
Dependent on
printer build.
U.S.
Non-U.S.
1. Press NEXT or PREVIOUS to
toggle between U.S. and NON-U.S.
2. Press SELECT to choose and set
the factory defaults.
Display Language
This submenu allows you to change
the language of the display
messages.
English
English
Francais (French)
Deutsch (German)
Italiano (Italian)
Espanol (Spanish)
1. Press NEXT or PREVIOUS to
scroll through the available
languages: English, French
(Francais), German (Deutsch),
Italian (Italiano), or Spanish
(Espanol).
2. Press SELECT to choose and set
the language.
Power Saver
This is the number of minutes of idle
time before the printer goes into
power saver mode. In this mode, the
printer will turn off internal motors,
fuser heat, and fan.
15
1 – 60
1. Press NEXT or PREVIOUS to
increase or decrease the digit.
2. Press SELECT to save this setting.
Wait Timeout
This submenu allows you to increase
or decrease the length of time (in
seconds) that the printer will remain
in the waiting state—a job is being
processed, no end-of-file has been
detected, and there is no more data
to process. This setting applies to
both PCL and PostScript print jobs.
00020
0 – 99999
1. Press NEXT or PREVIOUS to
increase or decrease each digit of
the five-digit number.
2. Press SELECT set one digit and
move to the next digit.
3. Press SELECT after changing the
last digit to save this setting.
Summary of Contents for 9045N
Page 1: ...Jul 07 User Guide TallyGenicom 9045N Laser Printer...
Page 29: ...Jul 07 45 PPM Laser Printer User Guide 2 3 Printing a Configuration Summary...
Page 120: ...Jul 07 4 26 45 PPM Laser Printer User Guide When Moving the Printer...
Page 127: ...Jul 07 45 PPM Laser Printer User Guide 5 7 At the Fuser Unit 6 Open and close the top cover...
