Tally T9114, Installation And Programming Manual

Page: 8 / 32

Seite -8-
4
Unpack the SIMM module.
Notes: Avoid touching the connection points along
the edge.
Save the packaging.
6
5
Hold the SIMM module with the connection points
pointing toward the connector and position the notch
as shown. Insert the memory option all the way into
the connector at a 30
O angle, and rotate it left until
it snaps into place.
6
6
Make sure both metal clips on the connector are
fastened, and the two pins on each of the connectors
are pushed through the holes on the SIMM module.
7
Close the metal plate and tighten all the screws.
8
Set the bottom of the cover onto the printer. Make
sure the bottom tabs on the cover fit into the
corresponding slots in the printer. Rotate the cover
up towards the printer. Slide the cover toward the
front of the printer until it clicks into place.
PostScript module
Memory module