VOIP-600
Series Phone
Configuration / Operation Manual
Page
36
of
94
Rev. 9/17/2014
Copyright 2014 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.7. Digital Outputs
4.7.1. Digital Output Scripts
The VOIP-600 supports ASCII digital outputs to third-party devices. The Digital Outputs – Scripts page allows
for creation of scripts that will run when activated on the Digital Outputs – Events page.
Login → Digital Outputs → Scripts
Figure 18 Digital Outputs - Scripts
To create Digital Output Scripts:
1.
Use the drop-down menu to select the
Digital Output Script slot
, and assign a
label
.
2.
Enter a script to be run as follows:
i. The entire script cannot exceed 300 characters.
ii. The scripting engine supports the following commands:
i.
echo
This command is used to declare the message content
ii.
nc
This command is used to declare which server to communicate with
iii.
|
The pipe symbol is used to pass the output of one command to the input of another
iv.
+
The plus symbol is used to separate multiple command sets
iii. The
echo
command is used to declare the message content.
Proper usage is:
echo “message content”
Example:
echo “activate cam_1”
iv. The
nc
(netcat) command is used to declare which server to communicate with.
Proper usage is:
nc <IP_ADDRESS> <PORT>
Example:
nc 192.168.1.100 23
v. The
|
(pipe) symbol is used to pass the output of one command to the input of another. In this context,
we utilized the pipe to pass the message content (echo) to the server connection (nc).
Example:
echo “activate cam_1” | nc 192.168.1.100 23
vi. The + (plus) symbol is used to separate multiple command sets.
1
3
4
2
