Area of Refuge Command Unit
Installation Instructions
Model AOR-24/AOR-32
Page
3
of
13
Rev. 10/15/2015
Copyright 2014 Talk-A-Phone Co.
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice.
Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.
4.
Remove the telephone by sliding it upwards ½ [in] then lifting away from the
unit and out of the compartment. This will expose a mounting location within the
telephone compartment.
5.
After installation, reinstall the telephone within its compartment by holding the
phone against the rear surface of the compartment and sliding ½ [in]
downward. If the phone will not slide downward into locking position, the 6-32
screws located behind the phone may need to be adjusted. Loosen the screws
¼ turn by hand and repeat step 8. Likewise, if the telephone slides correctly
downward but does not feel secure in place, tighten the nuts ¼ turn by hand
and repeat step 8. Plug phone and power connections back into phone in the
correct order.
6.
Remove the three (3) Phillips screws from the left side of the unit which secure
the hinged front cover shut.
7.
Carefully open the hinged front cover taking care there are no loose items
which may have shifted during transportation.
8.
The
AOR-24/AOR-32
may be either surface mounted onto a wall or flush
mounted into a wall.
NOTE:
For flush mounting units,
AOR-24
and
AOR-32
units should be
ordered with the available
AOR-TR32
Flush Mount Trim Ring (sold
separately).
NOTE:
Conduit knockouts exist on the rear, top, and bottom sides of the
enclosure for access to power and communication lines. Determine the
method of bringing in these power and communication lines
before
mounting the enclosure.
NOTE:
Whenever possible, it is best to keep the maximum clearance
possible between analog phone lines and alternating current. Running
phone lines too close to hot VAC lines will produce undesired effects on
the phone line.
9.
For mounting the unit directly to the surface of an interior wall,
10.
The
AOR-24/AOR32
has four (4) surface mounting keyholes. These keyholes
are visible upon product arrival. The first of the two remaining keyholes is
located behind the built in telephone. To remove the built in telephone,
Summary of Contents for AOR-8
Page 1: ......
