Taktis Incite Fire S3, Operating Instructions Manual

Page: 134 / 211

Installation 3
Taktis Fire Control Panel - Installation Manual
Man-1154-In, Revision E01.02
63 of 156
To connect standby-batteries of the Taktis Fire Control Panel:
The figure below illustrates standby-battery connections of the 5.25 Amp Power Supply:
Figure 3-11
Connecting Standby-Batteries of the 5.25 Amp Power Supply
1 Place two 12 VDC, SLA, re-chargeable, standby-batteries in the base of the Taktis Fire Control Panel cabinet.
2 Orient terminals of the standby-batteries so that the positive ( + ) terminal of one standby-battery is facing the
negative ( - ) terminal of the other.
3 Connect the black wire of the power supply to the negative ( - ) terminal of Battery 1.
4 Connect the red wire of the power supply to the positive ( + ) terminal of Battery 2.
5 Connect the jumper-wire to the remaining positive and negative terminals of Battery 1 and Battery 2.
The series connection of the
standby-batteries shown provides
the 24 volts required to operate
standby.
Do not connect standby-batteries
in parallel. A parallel connection
will not provide the 24 volts
necessary to operate standby.