M10510B;35/58
- 35 -
(Note)
“With Fast-dump” setting gets invalid except in Preset/Asynchronous shutter operation.
(Note)
Carefully note that the operation is not guaranteed if an unusable function is selected.
[Shutter mode]
●
Functional limitation by shutter mode
*1……Usable only in preset/asynchronous shutter operation.
(7-9) Read out of factory default
This procedure is for reading out the factory default (initial setting before shipment) in order to initialize the setting that was
changed by the user after purchase.
The factory default is shown by the table below.
[Factory default of each register]
Storage area (Register)
Factory default
Program page item
(Stored in each program page)
※
Applied to page A to F
Flag register (FR)
FR = H’0000
MGC gain set value
(Factory default)
AGC gain set value
(Factory default)
Offset set value
(Factory default)
Direct designated value of shutter speed
H’0000 (none specified)
Electric shutter table
Contents of table 5-3
Configuration item
(Stored in common area)
Configuration register (CR)
CR=H’0008
Hypothetical shutter switch
0
Hypothetical mode switch
A
ID data
Blank
Vsub voltage set value
(Factory default)
(Note) (Factory default) is the adjusted value for each camera.
(!) The factory setting of configuration register for this camera is CR=H’0008 and the image output format is 8bit.
[The procedure for restoring the setting to factory default]
①
Transmit “ e ” command by serial communication.
②
Turn off the power to the camera. Several seconds after that , restore the power.
→
The settings inside the camera (contents of nonvolatile EEPROM) are restored to the factory default of the upper table by this
operation.
(Note) Note that the contents having being set by the user are all lost by executing upper procedures.
Current shutter mode
AGC
operation
AEC
operation
Auto iris lens
Draft scan
Prolonged exposure Fast-dump
No shutter
O
O
O
O
O
X
Continuous shutter
O
O
O
O
O
X
Asynchronous shutter
X
X
X
X
X
O *1
It is free to download FCTool from the website of TAKENAKA SYSTEM Co.,Ltd.
http://www.takex-system.co.jp/
Takenaka’s free software ”FCTool” is available to set parameters inside the camera
via serial communication at the time of product evaluation or initial setting.
Product introduction
Communication software for evaluation
FCTool