18
GB
07 Operating
manual
Finally: you are about to bath for the first time in your
whirltub! We wish you a lot of pleasure in your new bathtub!
The fact that you have a highest quality product is the
effect of constant monitoring of the product, research
and development works in connection with the innovative
design of our luxurious bathtubs made of sanitary acrylic.
However, in order for your bathing not to be disturbed, we
suggest reading this manual first.
08 Introduction
08.01 How does the whirl system function?
Whirl system installation has closed circulation. Drain valve is,
at the same time, a suction bracket. Water is sucked,
fl
owed by
water pump and directed with 1 bar pressure through jets inside
the bathtub. Thanks to sub-pressure the self-aeration of water
stream takes place (possibility to turn on/turn off with remote
control). Pipes between jets and water pump are installed in
the way that they are made empty at the releasing water from
the bath. In Whirlpower-System additional air is added from the
blower, what causes even more powerful massage. Thanks to
rotating jets, this massage stream is evenly distributed throughout
the entire body.
08.02 How does the Air system function?
The air sucked by the blower is carried by air pipes located under
the bottom of the bathtub and via bottom nozzles to the inside of
the bathtub full of water.
09
Functions of TAKE Relax Plus system
09.01 Control panel
1
3
4
5
6
7
8
9
12
11
10
2
After reaching the minimum water level, the whirltub is ready to work. The ready to work/standby status is indicated by the green LED diode.
1 Whirl system ON/OFF
Press the button
shortly. After switching the whirl system on
the pump starts working with full power.
2
By permanently pressing the +/- buttons
you can individually adjust the power. By
pressing/holding those buttons the pump
power is decreased or increased.
4 Air system ON/OFF
Press the button shortly.
After switching the Air system on the blower
switches on slowly to the medium power level.
5
By permanently pressing the +/- buttons
you can individually adjust the power. By
pressing/holding those buttons the blower
power is decreased or increased.
3/6 Interval mode ON/OFF
With the active interval mode the massage
power changes periodically from the lowest to
the highest.
In order to stop the interval mode press the
buttons again.
7 Plus Airsystem ON/OFF
Can be additionally switched on and off with
Whir Air.
8 Whirlpower ON/OFF
Can be additionally switched on and off in the
Whirl mode.
9 Underwater LED spotlights ON/OFF
During LED chrome therapy, white colour
is activated at pushing the button. Pressing
the button again turns on red, orange,
yellow, green, indygo, violet colours, colours
sequence I, colours sequence II. To turn off,
the button should be pressed continuously for
4 seconds.
10
Starts semi-automatic disinfection, hold the
button for min. 3 seconds.
11 Switch off everything
switching all functions off
12 LED display
green, yellow, red instead of
display module