Page 2.4
T
T
a
a
m
m
p
p
P
P
a
a
d
d
A
A
d
d
j
j
u
u
s
s
t
t
m
m
e
e
n
n
t
t
Adjustment of ( A ):
The height of the peel plate and the tamp pad will vary with different labels but, for a
place to start is to have the peel plate and the tamp pad to be even. You can move it up or
down from there. Watch the label move between the peel plate and the tamp pad, if the
label has to go up for the transfer of the label to the tamp pad, move the pad down. If the
label runs into the tamp pad you must move the tamp up. You can make fine adjustment of
the tamp by loosening the cylinder rod nut and turning the cylinder rod
( Don’t unthread
the rod too much or you could damage the thread when you run your labeler in
production )
.
Note: You want the tamp pad to be as low as possible without hitting the tamp pad.
A
B
Loosen For
Adjustment (A)
Cylinder Rod
Nut
C
Summary of Contents for TAL-3000C
